Remote buddy windows6/11/2023 In some edge cases, it might be necessary to delete both of these. Hard reset (USB with FW needed) - due to the complex partition layout, the firmware is storing its settings not only in the EEPROM but also on the XFLASH.Once, the reset is done, the printer will boot to language selection, followed by the calibration wizard. Technically speaking only the EEPROM with user stored data is deleted. For most of the cases, this is a sufficient method. Reset Settings & Calibrations - this option deletes all changes done by the user and reverts the system to its original state.This release splits the traditional “Factory reset” into two options: Improvements to the Factory Reset feature Note that the nozzle diameter has to be set correctly by the user in the settings menu of the printer. PrusaLink and Prusa Connect are now also informing the user about the installed nozzle. Prusa Connect and PrusaLink improvementsĭevelopers have optimized file transfers between Prusa Connect and the printer resulting in higher transfer speed. This release brings a small improvement and the user can now scroll through the list using the knob, previously it was necessary to press the knob to go through the list. The footer can be adjusted by the user and default values can be changed with multiple others (fan speeds, temperatures, filament sensor status, …). The value will remain saved until the end of print, then it will be reset back to zero. While the first layer is printed, press and hold the knob for a few seconds. However, in some edge cases, you might have a reason to adjust the offset between the nozzle and sheet surface manually. The Nextruder is equipped with loadcell technology and the vast majority of the first layers will be handled automatically by the internal algorithm. The printer bumps the right edge on the XL to align the tool changer pins.The Stallguard is now used when homing in Z for extra safety.Failed homing does not result in a red screen.Homing in the Z-axis is now more sensitive, fixing occasional firmer nozzle touches.The precision of homing in the X&Y axes was improved compared to the previous release.Homing algorithm has been improved in several ways. Similar adjustments were made to the print preview screen. New Home Screen and Print preview screenĭue to upcoming improvements, the logo was removed from the home screen, and the space was used to increase the size of icons. Once the user starts the print, firmware scans through the G-code and replaces MK3-specific commands for MK4. Starting this release you can print your old MK3/S/+ G-codes on the MK4 without issues. MK3/MK3S/MK3S+ G-code compatibility (MK4) Unless specified in the title, the changes described below are valid both for MK4 and XL. It will be part of the upcoming firmware release. Please note this bug fix release does not include the Input shaper. Kudos to the community for reporting the issues! This is the final release of firmware 4.6.1 focused on fixes and optimizations.
0 Comments
Leave a Reply. |